CANOGA PERKINS 9175 Command Reference - Manual (Page 243)

CanogaOS Command Reference
15-34
15.38 show ip ospf interface
To display Open Shortest Path First (OSPF)-related interface information, use the show ip ospf
interface command in EXEC mode.
Command Syntax
show ip ospf interface [interface-name]
interface-name (Optional) Interface name. If the interface-name argument is included, only
information for the specified interface is included.
Command Mode
EXEC
Usage
Examples
The following is sample output of the show ip ospf interface command when eth-0-3 is specified:
Switch# show ip ospf interface eth-0-3
eth-0-3 is up, line protocol is up
Internet Address 3.3.3.1/24, Area 3 [Stub], MTU 1500
Process ID 0, Router ID 10.0.0.1, Network Type NBMA, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 10.0.0.1, Interface Address 3.3.3.1
No backup designated router on this network
Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
Hello due in 00:00:17
Neighbor Count is 1, Adjacent neighbor count is 0
Crypt Sequence Number is 1218176990
Hello received 0 sent 80, DD received 0 sent 0
LS-Req received 0 sent 0, LS-Upd received 0 sent 0
LS-Ack received 0 sent 0, Discarded 0
Related Commands
15.39 show ip ospf neighbor
To display Open Shortest Path First (OSPF)-neighbor information on a per-interface basis, use the
show ip ospf neighbor command in privileged EXEC mode.
Command Syntax
show ip ospf neighbor [interface-name] [neighbor-id] [detail]
interface-name (Optional) Interface name.