CANOGA PERKINS 9175 Command Reference - Manual (Page 59)

CanogaOS Command Reference
4-15
Interface current state: Administratively DOWN
Hardware is Ethernet, address is bc3e.60b2.1601 (bia bc3e.60b2.1601)
Bandwidth 1000000 kbits
Index 1 , Metric 1 , Encapsulation ARPA , loopback not set
Speed - 1000Mb/s , Duplex - Full , Media type is 1000BASE_T
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off
The Maximum Frame Size is 1534 bytes
VRF binding: not bound
Label switching is disabled
No virtual circuit configured
ARP timeout 01:00:00, ARP retry interval 1s
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 input errors, 0 CRC
0 frame, 0 overrun, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 late collision
0 no carrier, 0 pause output
Related Commands
show interface status
4.22 show interface status
Use this command to display the brief information on all ethernet and LAG interfaces.
Command Syntax
show interface {IFNAME|}
IFNAME: the name of interface.
Command Mode
EXEC
Usage
This command will not show vlan and tunnel interfaces’ information.
Examples
This example shows how to display the brief information on all ethernet and LAG interfaces.
Switch# show interface status
Port Status Duplex Speed Mode Type Description