CANOGA PERKINS 9175 Command Reference - Manual (Page 289)

CanogaOS Command Reference
16-44
16.66 neighbor shutdown
Use this command to disable a neighbor.
Use the no parameter with this command to re-enable the neighbor.
Command Syntax
(no) neighbor NEIGHBORID shutdown
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used
with a command, the command applies on all peers in the specified group.
Command Mode
Router mode
Usage
This command shuts down any active session for the specified neighbor and clears all related routing data.
Examples
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router)# neighbor 10.10.0.72 shutdown
16.67 neighbor soft-reconfiguration inbound
Use this command to configure the zebos software to start storing updates.
Use the no parameter with this command to disable this function.
Command Syntax
(no) neighbor NEIGHBORID soft-reconfiguration inbound
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a command,
the command applies on all peers in the specified group.
Command Mode
Router mode and Address Family mode
Usage