CANOGA PERKINS 9175 Command Reference - Manual (Page 145)

CanogaOS Command Reference
8-9
Examples
This example shows how to disable srpt functionality for ERPS domain 11 ring 1.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#erps 11 ring 1 srpt disable
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: idle
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: eth-0-13
EPRS ring 1 SRPT is disabled
Related Commands
None
8.10 erps ring enable
Use this command to enable/disable specific erps ring instance.
Command Syntax
erps ERPS_ID ring RING_ID {enable | disable}
ERPS_ID: <1-255> ERPS domain ID
RING_ID: <1-255> ERPS ring ID
enable: enable the ring
disable: disable the ring
Command Mode
Global configuration
Usage
Upon the specific ERPS ring is enabled successfully, the ring state should leave the idle state.