CANOGA PERKINS 9175 Command Reference - Manual (Page 146)

CanogaOS Command Reference
8-10
Examples
This example shows how to enable ERPS domain 11 ring 1.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#erps 11 ring 1 enable
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 edge node mode: edge
ERPS ring 1 node state: link up
ERPS ring 1 edge interface name: eth-0-9
ERPS ring 1 common interface name: eth-0-13
EPRS ring 1 SRPT is disabled
Related Commands
None
8.11 erps enable
Use this command to enable/disable specific erps domain instance.
Command Syntax
erps ERPS_ID {enable | disable}
ERPS_ID <1-255>: ERPS domain ID
enable: enable the domain
disable: disable the domain
Command Mode
Global configuration
Usage
Enable the domain will make all the rings within the domain be enabled. Upon the specific ERPS ring is
enabled successfully, the ring state should leave the idle state.
Examples