CANOGA PERKINS 9175 Command Reference - Manual (Page 68)

CanogaOS Command Reference
5-1
5 LACP Commands
5.1 channel-group
Use the this command to assign a port to a channel group. Use the no form of this command to remove a
port from a channel group.
Command Syntax
channel-group channel-group-number mode {active | passive}
no channel-group
channel-group-number: <1-255>
Command Mode
Interface configuration
Usage
None
Examples
This example shows how to assign a port to a channel group 1:
Switch (config-if)# channel-group 1 mode active
This example shows how to remove a port from an channel group 1:
Switch (config-if)# no channel-group
Related Commands
None
5.2 lacp port-priority
Use this command to configure the port priority for the Link Aggregation Control Protocol (LACP). Use
the no form of this command to return to the default setting.
Command Syntax
lacp port-priority priority
priority: <1-65535>
Command Mode
Interface configuration
Defaults
32768
Usage