CANOGA PERKINS 9175 Command Reference - Manual (Page 435)

CanogaOS Command Reference
25-23
session:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp keepalive-interval 635
Related Commands
ldp keepalive-timeout
25.26 ldp keepalive-timeout
Use this command to set the keep-alive time-out value for rejecting a session
with a peer. Use the no parameter to revert to the keep-alive time-out set for the
main LDP process.
Command Syntax
(no) ldp keepalive-timeout number
Syntax De s cription
number Specifies the value in seconds, the range is 30
to 65535
Command Mode
Interface mode
Defaults
The default is 30 seconds.
Examples
In the following example, the ldp keepalive-timeout command is used to set
the keep-alive time-out value for rejecting a session with a peer:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp keepalive-timeout 635
Related Commands
ldp keepalive-interval