CANOGA PERKINS 9175 Command Reference - Manual (Page 152)

CanogaOS Command Reference
9-4
Usage
Configure dot1q-tunnel port’s native vlan.
Examples
Configure the eth-0-1 to dot1q-tunnel and configure this port’s native to vlan 10:
Switch (config)# vlan da
Switch (config-vlan)# vlan 100
Switch (config-vlan)# exit
Switch (config)# interface eth-0-23
Switch (config-if)# switchport mode dot1q-tunnel
Switch (config-if)# switchport dot1q-tunnel native vlan 100
Related Commands
show interface switchport
9.7 switchport dot1q-tunnel allow vlan
Use this command to configure dot1q-tunnel allowed vlan.
Command Syntax
switchport dot1q-tunnel allow vlan all
switchport dot1q-tunnel allow vlan none
switchport dot1q-tunnel allow vlan add VLAN_ID
switchport dot1q-tunnel allow vlan remove VLAN_ID
all: allow all vlans exist in system;
none: allow no vlan on this port;
Command Mode
Interface configuration
Usage
Configure dot1q-tunnel port’s allowed vlan. Only selective dot1q-tunnel port can be allowed to use this
command.
Examples
Switch (config-if)# switchport dot1q-tunnel allowed vlan add 100
Related Commands
show vlan
9.8 switchport dot1q-tunnel vlan mapping table
Use this command to apply vlan mapping table on selective dot1q tunnel port.
Command Syntax
switchport dot1q-tunnel vlan mapping table WORD