CANOGA PERKINS 9175 Command Reference - Manual (Page 233)

CanogaOS Command Reference
15-24
Default
1 second
Command Mode
Interface configuration
Usage
Link-state advertisements (LSAs) in the update packet must have their ages incremented by the amount
specified in the seconds argument before transmission. The value assigned should take into account the
transmission and propagation delays for the interface.
If the delay is not added before transmission over a link, the time in which the LSA propagates over the
link is not considered. This setting has more significance on very low-speed links.
Examples
The following example sets the retransmit delay value to 3 seconds:
interface eth-0-1
ip ospf transmit-delay 3
Related Commands
15.28 neighbor (OSPF)
To configure Open Shortest Path First (OSPF) routers interconnecting to nonbroadcast networks, use
the neighbor command in router configuration mode. To remove a configuration, use the no form of this
command.
Command Syntax
neighbor ip-address {[priority number] [poll-interval seconds] | [cost number]}
no neighbor ip-address [priority number] [poll-interval seconds] [cost number]
ip-address Interface IP address of the neighbor.
priority number (Optional) A number that indicates the router priority value of the
nonbroadcast neighbor associated with the IP address specified.
The default is 0. This keyword does not apply to
point-to-multipoint interfaces.
poll-interval seconds (Optional) A number value that represents the poll interval time (in
seconds). RFC 1247 recommends that this value be much larger
than the hello interval. The default is 120 seconds (2 minutes).
This keyword does not apply to point-to-multipoint interfaces. The
range is from 1 to 65535 seconds.
cost number (Optional) Assigns a cost to the neighbor, in the form of an integer
from 1 to 65535. Neighbors with no specific cost configured will
assume the cost of the interface, based on the ip ospf cost
command. For point-to-multipoint interfaces, the cost keyword and