CANOGA PERKINS 9175 Command Reference - Manual (Page 519)

CanogaOS Command Reference
29-1
29 VPLS Commands
29.1 mpls vpls-vlan
Use this command to create a block of continuous vlan id which are used for
vpls function.
Note:
This command will reserve a block of continuous vlan id, those
vlan id can not used for other purpose. And the number of vlan id
in this block determine the number of vpls instance. This
command is used to enable vpls function. When vpls instance
have been created, this block of vlan id can not be changed.
If vrf function is running, this command will fail.
Command Syntax
mpls vpls-vlan MIN-VLAN MAX-VLAN
Syntax Description
MIN-VLAN The minimal vlan id of the block of continuous
vlan id, the range is from 2 to 2094
MAX-VLAN The maximal vlan id of the block of continuous
vlan id, the range is from 2 to 2094
Command Mode
Configure mode
Defaults
This command has no default settings.
Examples
In the following example, the mpls vpls-vlan command is used to create a
block of continuous vlan id which are used for vpls function:
Switch # configure terminal
Switch (config)# mpls vpls-vlan 4000 4010
Related Commands
no mpls vpls-vlan