CANOGA PERKINS 9175 Command Reference - Manual (Page 733)

CanogaOS Command Reference
40-62
Examples
The following is sample output from the show usernames command.
Switch# show usernames
Number User name Privilege Password Rsa Key
=================================================================
1 Test_A 1 *
Related Commands
username
40.85 mac-address-table ageing-time
Use the mac-address-table aging-time global configuration command on the switch to set the length of
time that a dynamic entry remains in the MAC address table after the entry is used or updated. Use the
no form of this command to return to the default setting. The aging time applies to all VLANs.
Command Syntax
mac address-table aging-time ageing-time
no mac address-table aging-time
ageing-time Aging time in seconds. The range is 10 to 1000000 seconds.
Command Mode
Global configuration
Default
The default is 300 seconds.
Usage
If hosts do not send continuously, increase the aging time to record the dynamic entries for a longer time.
Increasing the time can reduce the possibility of flooding when the hosts send again.
Examples
This example shows how to set the aging time to 200 seconds for all VLANs:
Switch(config)# mac-address-table aging-time 200
You can verify your setting by entering the show mac address-table aging-time privileged EXEC
command.
Related Commands
show mac address-table aging-time