CANOGA PERKINS 9175 Command Reference - Manual (Page 246)

CanogaOS Command Reference
16-1
16 BGP Commands
16.1 address-family
Use this command to enter the IPv4, IPv6 or VPNv4 address-family command mode.
Command Syntax
address-family ipv4 (multicast|unicast|vrf)
address-family ipv6 (unicast)
address-family vpnv4 (unicast)
vpnv4 Configures sessions for VPN-IPv4 prefixes. This parameter takes an IPv4 style address: A.B.C.D.
ipv6 Configures sessions for VPN-IPv6 prefixes. This parameter takes an IPv6 style address: X:X::X:X.
multicast Specifies multicast prefixes.
unicast Specifies unicast prefixes.
vrf VPN routing/forwarding instance
Command Mode
Router mode
Usage
Use the address family command to enter the address family mode allowing configuration of address-family
specific parameters.
To leave the address family mode and return to the Configure mode use the exit-address-family command.
Examples
Switch# configure terminal
Switch(config) router bgp 7657
Switch(config-router) neighbor 3ffe:506::1 remote-as 7657
Switch(config-router) neighbor 3ffe:506::1 interface eth1
!
Switch# configure terminal
Switch(config) router bgp 7657
Switch(config-router)address-family ipv6
Switch(config-router-af)neighbor 3ffe:506::1 activate
Switch(config-router-af)exit-address-family
Related Commands
exit, exit-address-family