CANOGA PERKINS 9175 Command Reference - Manual (Page 62)

CanogaOS Command Reference
4-18
Defaults
disabled
Usage
When disable port-security, all the port-security mac address learned dynamically will be cleared. The
static port-security mac address will be disabled but not be cleared.
Examples
This example shows how to enable port security on an interface.
Switch(config-if)# switchport port-security
This example shows how to disable port security on an interface.
Switch(config-if)# no switchport port-security
Related Commands
show port-security interface
4.26 switchport port-security maximum
To set the maximum number of secure MAC addresses on a port, use the switchport port-security
maximum command. To return to the default settings, use the no form of this command.
Command Syntax
switchport port-security maximum maximum
no switchport port-security maximum
maximum :<1-4096> Maximum number of secure MAC addresses for the interface; valid values are
from 1 to 4096.
Command Mode
Interface configuration
Defaults
1
Usage
If you enter this command more than once, subsequent use of this command overrides the previous
value of maximum. If the new maximum argument is larger than the current number of the secured
addresses on this port, there is no effect except to increase the value of the maximum.
If the new maximum is smaller than the old maximum and there are more secure addresses on the old
maximum, the command is rejected.
If you configure fewer secure MAC addresses than the maximum number of secure MAC addresses on
the port, the remaining MAC addresses are dynamically learned.
Once the maximum number of secure MAC addresses for the port is reached, no more addresses are
learned on that port