CANOGA PERKINS 9175 Command Reference - Manual (Page 339)

CanogaOS Command Reference
19-8
Packet forwarding based on configured policies overrides packet forwarding specified in routing
tables.
Note:
This command is valid for BGP, OSPF and RIP only
Command Syntax
match ip next-hop ACCESSLISTID
no match ip next-hop [ ACCESSLISTID ]
Syntax Description
ACCESSLISTID Specify a IPv4 access-list name, up to 20 characters.
Command Mode
Route-map mode
Defaults
No match ip next-hop is specified by default.
Examples
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# match ip next-hop mylist
Related Commands
match community
match as-path
set as-path
set community
match metric
19.8 match ip next-hop prefix-list
Use this command to specify the next-hop IP address match criterion, using the prefix-list.
Use the no parameter with this command to remove the specified match criterion.
Use the match ip next-hop prefix-list command to match the next-hop IP address of a route.
Note:
This command is valid for BGP and RIP only
Command Syntax