CANOGA PERKINS 9175 Command Reference - Manual (Page 523)

CanogaOS Command Reference
29-5
vpls-description
29.7 vpls-mtu
Use this command to set mtu for VPLS instance.
Note:
If set the MTU value for the VPLS instance, LDP will advertise this
value to peers in the instance.
Command Syntax
vpls-mtu MTU
Syntax Description
MTU MTU value for the VPLS instance, the range is
from 576 to 65535.
Command Mode
VPLS mode
Defaults
This command has no default settings.
Examples
In the following example, the vpls-mtu command is used to set mtu for VPLS
instance:
Switch# configure terminal
Switch(config)#mpls vpls vpls1 1
Switch(config-vpls)# vpls-mtu 55555
Related Commands
29.8 no vpls-mtuno vpls-mtu
Use this command to unset mtu for VPLS instance.
Command Syntax
no vpls-mtu
Syntax Description
This command has no arguments or keywords.
Command Mode
VPLS mode