CANOGA PERKINS 9175 Command Reference - Manual (Page 34)

CanogaOS Command Reference
2-3
Switch(config)# vlan database
Switch(config-vlan)#
The supported commands can vary depending on the version of software in use. To
view a comprehensive list of commands, enter a question mark (?) at the prompt:
Switch(config-vlan)# ?
To return to privileged EXEC mode, enter the abort VLAN configuration command to
abandon the proposed database. Otherwise, enter exit to implement the proposed new
VLAN database and to return to privileged EXEC mode. When you enter exit or apply,
the configuration is saved in the VLAN database; configuration from VLAN
configuration mode cannot be saved in the switch configuration file.
2.6 Line Configuration Mode
Line configuration commands modify the operation of a terminal line. Line configuration
commands always follow a line command, which defines a line number. Use these
commands to change terminal parameter settings line-by-line or for a range of lines.
Use the line vty line_number [ending_line_number] command to enter line
configuration mode. The new prompt means line configuration mode. The following
example shows how to enter line configuration mode for virtual terminal line 7:
Switch(config)# line vty 0 7
The supported commands can vary depending on the version of software in use. To
view a comprehensive list of commands, enter a question mark (?) at the prompt:
Switch(config-line)# ?
To exit line configuration mode and to return to global configuration mode, use the exit
command. To exit line configuration mode and to return to privileged EXEC mode,
enter the end command, or press Ctrl-Z.
2.7 Linecard Configuration Mode
Linecard configuration commands modify the operation of a line card. Linecard
configuration commands always follow a line card, which defines a line card. Use the
line card SLOT command to enter linecard configuration mode. The new prompt
means linecard configuration mode. The following example shows how to enter
linecard configuration mode for virtual linecard 6:
Switch(config)# line card 6
The supported commands can vary depending on the version of software in use. To
view a comprehensive list of commands, enter a question mark (?) at the prompt:
Switch(config-card)# ?
To exit line configuration mode and to return to global configuration mode, use the exit
command. To exit line configuration mode and to return to privileged EXEC mode,
enter the end command, or press Ctrl-Z