CANOGA PERKINS 9175 Command Reference - Manual (Page 532)

CanogaOS Command Reference
30-1
30 MPLS OAM Commnands
30.1 ping mpls ipv4
Use this command to initiate checking MPLS host reachability and network
connectivity by specifying the destination type as a Label Distribution Protocol
(LDP) IPv4 address.
Command Syntax
ping mpls ipv4 A.B.C.D/M [destination A.B.C.D | detail | dsmap | flags |
interval INT_VAL | repeat REP_VAL | reply-mode MODE | source A.B.C.D |
timeout TIME_OUT | ttl TTL_VAL]
Syntax Description
A.B.C.D/M Address prefix of the target and number of bits
in the target address network mask.
destination
A.B.C.D Specifies a network 127/8 address to be used
as the destination address in the echo request
packet.
detail Enables verbose output information, including
MPLS echo reply, sender address of the
packet, and return codes.
dsmap Indicates that a downstream mapping
(DSMAP) type length and value should be
included in the LSP echo request.
flags Received LSR must do an FEC stack
validation. Optional. Default is disabled.
interval
INT_VAL Specifies a send interval between requests (in
milliseconds). The range is from 2 to
20000.Default is 2.
repeat
REP_VAL Specifies the number of times to resend a
packet. The range is from 1 to 5000. Default is
5.
reply-mode
MODE Specifies the reply mode for the echo request
packet.
z Reply with IP UDP packet (default)
z Reply with IP UDP packet with router alert
source A.B.C.D Specifies the source address used in the echo
request packet.
timeout
TIME_OUT Specifies the timeout interval in seconds. The
range is from 1 to 500. Default is 60.
ttl TTL_VAL Specifies the TTL value to be used in the
MPLS labels.
The range is from 1 to 255. Default is 255.