CANOGA PERKINS 9175 Command Reference - Manual (Page 224)

CanogaOS Command Reference
15-15
15.16 ip ospf cost
To explicitly specify the cost of sending a packet on an interface, use the ip ospf cost command in
interface configuration mode. To reset the path cost to the default value, use the no form of this
command.
Command Syntax
ip ospf cost interface-cost
no ip ospf cost
interface-cost Unsigned integer value expressed as the link-state metric. It can be a value in
the range from 1 to 65535.
Default
No default cost is predefined.
Command Mode
Interface configuration
Usage
You can set the metric manually using this command, if you need to change the default. Using the
bandwidth command changes the link cost as long as this command is not used.
The link-state metric is advertised as the link cost in the router link advertisement.
In general, the path cost is calculated using the following formula:
10 8 / bandwidth
Examples
The following example sets the interface cost value to 65:
Switch(config-if)# ip ospf cost 65
Related Commands
15.17 ip ospf database-filter all out
To filter outgoing link-state advertisements (LSAs) to an Open Shortest Path First (OSPF) interface, use
the ip ospf database-filter all out command in interface configuration mode. To restore the forwarding
of LSAs to the interface, use the no form of this command.
Command Syntax
ip ospf database-filter all out
no ip ospf database-filter all out
Default
This command is disabled by default. All outgoing LSAs are flooded to the interface.