CANOGA PERKINS 9175 Command Reference - Manual (Page 303)

CanogaOS Command Reference
16-58
show ip bgp ipv4 PREFIX neighbors (IPADDRESS
(advertised-routes|RECEIVED|receivedroutes|routes))
IPADDRESS=A.B.C.D|X:X::X:X Specifies the IP address.
A.B.C.D Specifies an IPv4 address.
X:X::X:X Specifies an IPv6 address
advertised-routes Displays the routes advertised to a BGP neighbor.
RECEIVED = received prefix-filter Displays all received routes, both accepted and rejected.
prefix-filter Displays the prefix-list filter.
received-routes Displays the received routes from neighbor. To display all the received routes from the
neighbor, configure the BGP soft reconfigure first. routes Displays all accepted routes learned from
neighbors.
ipv4 Specifies the address family. The type of address family determines the routing table that is
displayed.
PREFIX = multicast|unicast
unicast Specifies a IPv4 unicast address family. This is the default option.
multicast Specifies a IPv4 multicast address family.
Command Mode
Privileged Exec mode and Exec mode
Examples
This is a sample output from the show ip bgp neighbors command displaying information about the
specified neighbor.
Switch# show ip bgp neighbors
BGP neighbor is 192.10.23.67, remote AS 1, local AS 1, internal link
BGP version 4, remote router ID 172.22.10.10
BGP state = Established, up for 00:00:22
Last read 00:00:22, hold time is 240, keepalive interval is 60 seconds
Neighbor capabilities:
Route refresh: advertised and received (old and new)
Address family IPv4 Unicast: advertised and received
Received 3 messages, 0 notifications, 0 in queue
Sent 3 messages, 0 notifications, 0 in queue
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP table version 1, neighbor version 1
Index 1, Offset 0, Mask 0x2
AF-dependant capabilities:
Graceful restart: advertised, received
Community attribute sent to this neighbor (both)
0 accepted prefixes
0 announced prefixes
Connections established 1; dropped 0
Graceful-restart Status:
Remote restart-time is 120 sec