CANOGA PERKINS 9175 Command Reference - Manual (Page 346)

CanogaOS Command Reference
19-15
Switch(config-route-map)# set aggregator as 43 10.10.0.3
Related Commands
19.15 set as-path
Use this command to modify an autonomous system path for a route.
Use the no parameter with this command to disable this function.
Use the set as-path command to specify an autonomous system path. By specifying the length
of the AS-Path, the router influences the best path selection by a neighbor. Use the prepend
parameter with this command to prepend an AS path string to routes increasing the AS path
length.
To use the set as-path command, you must first have a match clause. Match and set commands
set the conditions for redistributing routes from one routing protocol to another. The match
command specifies the match criteria under which redistribution is allowed for the current
route-map. The set command specifies the set redistribution actions to be performed, if the
match criteria are met.
If the packets do not match any of the defined criteria, they are routed through the normal
routing process.
Note:
This command is valid for BGP only.
Command Syntax
set as-path prepend ASN […ASN ]
no set as-path
Syntax Description
prepend Prepends the autonomous system path.
ASN System prepends this number to the AS path.
Command Mode
Route-map mode
Defaults
No set as-path is specified by default.
Examples
Switch# configure terminal
Switch(config)# route-map myroute permit 3