CANOGA PERKINS 9175 Command Reference - Manual (Page 433)

CanogaOS Command Reference
25-21
(no) ldp hello-interval number
Syntax Description
number Specifies the interval in seconds, the range is 1
to 21845
Command Mode
Interface mode
Defaults
The default is 5 seconds.
Examples
In the following example, the ldp hello-interval command is used to set the
interval for sending multicast Hello packets via an interface:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# ldp hello-interval 635
Related Commands
hello-interval
hold-time
ldp hold-time
25.24 ldp hold-time
Use this command to set the hold-time value after which the LSR rejects
adjacencies. Use the no parameter to revert to the hold-time value set for the
main LDP process.
Command Syntax
(no) ldp hold-time number
Syntax Description
number Specifies the hold-time value in seconds, the
range is 3 to 65535
Command Mode
Interface mode