CANOGA PERKINS 9175 Command Reference - Manual (Page 642)

CanogaOS Command Reference
37-5
Related Commands
show dot1x
37.7 dot1x re-authenticae
Use the dot1x re-authenticate privileged EXEC command on the switch stack to manually initiate a
re-authentication of the specified IEEE 802.1x-enabled port.
Command Syntax
dot1x re-authenticate interface interface-name
interface-name The interface to re-authenticate.
Command Mode
Privileged EXEC
Usage
You can use this command to re-authenticate a client without waiting for the configured number of
seconds between re-authentication attempts (re-authperiod) and automatic re-authentication.
Examples
The following is sample output from the dot1x re-authente command:
Switch# dot1x re-authenticate interface eth-0-1
Related Commands
show dot1x
37.8 dot1x timeout
Use the dot1x timeout interface configuration command on the switch stack or on a standalone switch
to set IEEE 802.1x timers. Use the no form of this command to return to the default setting.
Command Syntax
dot1x timeout {reauth-period seconds | server-timeout seconds | supp-timeout seconds |
tx-period seconds}
no dot1x timeout {reauth-period | server-timeout | supp-timeout | tx-period}
reauth-period seconds Set the number of seconds between re-authentication attempts.
The number of seconds from 1 to 65535; the default is 3600
seconds.
server-timeout seconds Number of seconds that the switch waits for the retransmission of
packets by the switch to the authentication server. The range is 1
to 65535.
supp-timeout seconds Number of seconds that the switch waits for the retransmission of