CANOGA PERKINS 9175 Command Reference - Manual (Page 609)

CanogaOS Command Reference
33-18
Usage
The fragments will be invalid when the layer 4 information is specified (i.e. src-port).
Examples
This example shows how to create a filter in IP ACL to permit any TCP packets.
Switch(config-ip-acl)#10 permit tcp any any
This example shows how to create a filter in IP ACL to permit the TCP packets with the source IP
address 1.1.1.1, and source port ranges from 0 to 100.
Switch(config-ip-acl)#20 permit tcp host 1.1.1.1 src-port range 0 100 any
This example shows how to create a filter in IP ACL to permit any TCP packets in established TCP
streams.
Switch(config-ip-acl)#30 permit tcp any any establised
This example shows how to create a filter in IP ACL to permit the TCP ACK packets with the source IP
address 10.10.10.0.
Switch(config-ip-acl)#4 permit tcp 10.10.10.0 0.0.0.0 any match-any ack
Related Commands
permit
permit udp
permit icmp
permit igmp
33.25 permit udp
Use this command to permit UDP packets when the packets match this access-list.
Command Syntax
[<1-2147483646>] permit udp { source source-mask | any | host source } [ src-port operator
port ]{destination destination-mask any | host destination} [ dst-port operator port ] [ ip-precedence
precedence | dscp dscp ] [ fragments ] [ routed-packet ] [ options ] [ time-range time-range-name ]
[ stats ]
src-port: source port <0-65535>
dst-port: destination port <0-65535>
operator ˖including eq (equal to), lt (less than), gt (greater than), neq (not equal to), range
port: the port should be in the range <0-65535>
reference to command permit for other parameters
Command Mode
IP ACL configuration
Usage
The fragments will be invalid when the layer 4 information is specified (i.e. src-port).