CANOGA PERKINS 9175 Command Reference - Manual (Page 101)

CanogaOS Command Reference
6-11
This example shows how to set the switchport mode to access.
Switch(config-if)# switchport mode access
Related Commands
switchport mode trunk
6.18 switchport mode trunk
Use this command to set the switchport mode to trunk.
Command Syntax
switchport mode trunk
Command Mode
Interface configuration
Usage
The trunk mode is usually used to connect the port with other switch.
The trunk mode is usually used to connect the port with host device.
When the mode is changed, both the mac learned dynamically and configured statically on the port will
be cleared.
Examples
This example shows how to set the switchport mode to trunk.
Switch(config-if)# switchport mode trunk
switchport mode trunk ingress-filter {enable |disable}
enable: enable the ingress-filter
disable: disable the ingress-filter
Command Mode
Interface configuration
Related Commands
switchport mode access
6.19 switchport mode trunk ingress-filter
Use this command to set ingress-filter configuration of the trunk port .
Command Syntax
Defaults
enable