CANOGA PERKINS 9175 Command Reference - Manual (Page 535)

30-4
request packet.
destination
A.B.C.D Specifies a network 127/8 address to be used
as the destination address in the echo request
packet.
detail Enables verbose output information, including
MPLS echo reply, sender address of the
packet, and return codes.
dsmap Indicates that a downstream mapping
(DSMAP) type length and value should be
included in the LSP echo request.
flags Received LSR must do an FEC stack
validation. Optional. Default is disabled.
interval
INT_VAL Specifies a send interval between requests (in
milliseconds). The range is from 2 to
20000.Default is 2.
repeat
REP_VAL Specifies the number of times to resend a
packet. The range is from 1 to 5000. Default is
5.
reply-mode
MODE Specifies the reply mode for the echo request
packet.
z Reply with IP UDP packet (default)
z Reply with IP UDP packet with router alert
timeout
TIME_OUT Specifies the timeout interval in seconds. The
range is from 1 to 500. Default is 60.
ttl TTL_VAL Specifies the TTL value to be used in the
MPLS labels.
The range is from 1 to 255. Default is 255.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the ping mpls l3vpn command is used to initiate
sending MPLS echo request packets in the specified VPN instance of the
MPLS cloud.
Switch# ping mpls l3vpn vpn1 1.1.1.0/24 source 10.10.10.10 destination 127.0.0.1
dsmap detail flags interval 100 repeat 100 reply-mode timeout 100 ttl 200
Related Commands
traceroute mpls l3vpn
CanogaOS Command Reference