CANOGA PERKINS 9175 Command Reference - Manual (Page 533)

CanogaOS Command Reference
30-2
Command Mode
Privileged EXEC mode
Defaults
This command has no default settings.
Examples
In the following example, the ping mpls ipv4 command is used to initiate
checking MPLS host reachability and network connectivity by specifying the
destination type as a Label Distribution Protocol (LDP) IPv4 address.
Switch# ping mpls ipv4 1.1.1.1/24 destination 127.0.0.1 dsmap detail flags
interval 100 repeat 100 reply-mode 1 source 1.1.1.1 timeout 100 ttl 200
Related Commands
30.2 traceroute mpls ipv4ping mpls l2-circuit
Use this command to initiate sending MPLS echo request packets in the
specified Layer-2 Virtual Circuit (VC) of the MPLS cloud.
Command Syntax
ping mpls l2-circuit VC_ID source A.B.C.D [destination A.B.C.D | detail |
dsmap | flags | interval INT_VAL | repeat REP_VAL | reply-mode MODE |
timeout TIME_OUT | ttl TTL_VAL]
Syntax Description
VC_ID Layer-2 VC ID
source A.B.C.D Specifies the source address used in the echo
request packet.
destination
A.B.C.D Specifies a network 127/8 address to be used
as the destination address in the echo request
packet.
detail Enables verbose output information, including
MPLS echo reply, sender address of the
packet, and return codes.
dsmap Indicates that a downstream mapping
(DSMAP) type length and value should be
included in the LSP echo request.
flags Received LSR must do an FEC stack
validation. Optional. Default is disabled.
interval
INT_VAL Specifies a send interval between requests (in
milliseconds). The range is from 2 to