CANOGA PERKINS 9175 Command Reference - Manual (Page 713)

CanogaOS Command Reference
40-42
state PIM state.
timer PIM timers.
Command Mode
Privileged EXEC
Usage
PIM uses Internet Group Management Protocol (IGMP) packets to communicate with switches and
advertise reachability information.
Use this command with the debug igmp commands to display additional multicast routing information.
Examples
The following is sample output from the debug pim sparse-mode command:
Switch# debug pim sparse-mode
Related Commands
debug igmp
40.56 show debugging
To display information about the types of debugging that are enabled for your switch, use the show
debugging command in privileged EXEC mode.
Command Syntax
show debugging {arp [vrf name] | bgp | chsm | dhcp {relay | snooping} | dot1x | igmp | ipsour
guard | ipv6 nd | nsm | ospf | pim sparse-mode | rip | status | stp | vrrp}
arp For module arp.
bgp Border Gateway Protocol (BGP).
chsm For module chsm.
dhcp For module dhcp.
relay For module dhcp relay.
snooping For module dhcp snooping.
dot1x IEEE 802.1X Port-Based Access Control.
igmp Internet Group Management Protocol (IGMP).
ipsour guard For module IP source guard.
ipv6 nd Pv6 Neighbor Discovery.
ldp Label Distribution Protocol (LDP).
nsm Network Service Module (NSM).
ospf Open Shortest Path First (OSPF).
pim sparse-mode Protocol Independent Multicast (PIM).
rip Routing information protocol (RIP).
status Show debugging status.
stp Spanning Tree Protocols (STP/RSTP/MSTP).
vrrp Virtual Router Redundancy Protocol (VRRP).