13 setting up the control server, 13 setting up the control server -57, Index – Yokogawa DAQWORX User Manual
Page 77: Entering control server settings
2-57
IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Configuring the DAQLOGGER
2.13 Setting Up the Control Server
Entering Control Server Settings
The control server forwards each control request that is sent from the remote control
software (see chapter 8) to the manager software.
Procedure
1. Press the C.SERV button in the DAQLOGGER Manager window.
Starts the control server
When using the DAQLOGGER for the first time after installation, the Login Password
window is displayed.
Enter the password to be used for the remote control software. Enter it again in the
Confirm box, then click OK. The DAQLOGGER Control Server window appears.
The host name of the PC that will be sending the remote controls may appear in the
Host Name tab.
The following communications history information may appear in the Log tab. The
newest history and/or selected history are highlighted.
Protect Cancel:
Password protection cancelled by the controller.
Protect ERROR:
Protect Cancel failed.
Connect ERROR:
Connection was cut.
Port Open:
The port is open.
Port Close:
The port is closed.
Open Error:
Open port failed.
Login:
Password required.
Host:***:
Host [***] is connected.
Logout:
Remote controller logged out.
LoginERROR:
Remote control login failed.
Scan Start:
Received scan start command.
Record Start:
Received record start command.