Yokogawa DAQWORX - Manual (Page 441)

7-265 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
3. When the setting parameters have been sent, a “Communication Message” dialog
box appears.
Read the message and click “OK.”
Note
• Communication is not possible of the scanning or the recording is in progress.
• With the VR series, the settings data of “SETUP” cannot be sent to the recorder.
• With the DX/MV/CX series, the settings of network in the “Setup” tab panel cannot be sent
to the recorder, except for the setting of memory data output destination.
• Use the “File Export” function to set both series.
• Before connecting the hardware, check if Module Configuration matches the actual module
construction.
• If a file remains in the internal RAM disk of the DC100, it is not possible to send settings
to its internal RAM disk. Initialize the internal DC100 RAM disk before sending data to the
DC100, or initialize the DC100 using this software. In that case, make sure to first copy
important files.
• If files remain on the DC100 internal RAM disk, when sending data to the DC100 the writing
action does not change automatically to SINGLE or REPEAT, when it was earlier set to
NONE on the DC100, and likewise, not to NONE if it is set to SINGLE or REPEAT on the
DC100.
• If files remain on the DC100 internal RAM disk, when sending data to the DC100 , the
periodic file type does not change automatically to Meas or Report, when it was earlier set to
NONE on the DC100, and likewise, not to NONE if it is set to Meas or Report on the DC100.
• If data are sent, during computation, reporting, or (for DC only) data writing, those actions
will be canceled.
• If data are sent, during balancing for strain input or (for DR only) data writing to the internal
RAM disk, a communication error will be detected.
• If only altered settings are send event/action, Math, Report, or Memory Pause, LEVEL
actions, will not be canceled.
• When using Ethernet communication, error detection may take a few minutes.
7.11 Writing Setting Parameters to the Recorder