Yokogawa DAQWORX - Manual (Page 445)

7-269 IM WX101-01E
1
2
3
4
5
6
7
8
9
Index
Setting the Recorder
3 If you click “Open” the data will be downloaded. If the setting data which are at that
time being edited aren’t saved yet, you will be asked whether to save them or not. A
warning will be displayed, if all data can’t be loaded.
Note
When data were acquired with the DC100, a message may appear warning you that some
changes have taken place. In that case, please check if all data have been acquired.
Exporting Files
Save the settings data edited using “DAQLOGGER Hardware Configurator” in a settings
file.
This function is used to configure the recorder with the settings data edited using
“DAQLOGGER Hardware Configurator” via a floppy disk.
The settings that cannot be done via communication are the setup mode setting of the
VR series and the network settings of the DX/MV/CX series.
Procedure
1. For “setup” of the VR series, in the menu bar of the “DAQLOGGER Hardware
Configurator” window, select “File”-“File Export,” then “Set Mode” or “Setup Mode.”
For “setup” of the DX, MV, CX, DR, and DC recorders, in the menu bar of the
“DAQLOGGER Hardware Configurator” window, select “File”-“File Export.”
The “Save As” dialog box opens.
VR, DX, MV, CX
(File names)
7.13 Handling Setting Data Using a Floppy Disk