Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 760)

Section 15B
Replacement Procedures
15B-4
3. When you press a key, this screen appears:
Copying...
Insert backup diskette 01 in drive A:
Strike any key when ready
4. Insert the next disk and strike a key when the update prompts you to
do so. If you have additional disks in your update package, repeat this
step for those disks. The screen may display more files being read by
the computer than shown here. When prompted, strike any key.
Copying...
Insert backup diskette 01 in drive A:
Strike any key when ready
*** Files were backed up 12-31-1999 ***
*** Resstoring file from drive A:
Diskette: 01
\SYS0201.ZIP
5. When you press a key, these screens appear. When decompression is
complete, power down the control and connect the RS-232 cable as
instructed on the screen.
Copying is complete.
The system file was compressed on floppy disk to conserve
storage space, and minimize the number of required disks.
It must now be decompressed.
Decompressing is complete
In order to download the system updates,
the CNC and PC must first be connected.
Power down the CNC.
Connect the RS-232 cable from CNC port B to PC port COM1.
Then restart the CNC.
Press a key when ready...
PC Screen
Informative Messages
Connected to Host
Error Messages
Control Screen