Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 576)

I/O Interface
Section 10A
10A-53
2. Wire the power supply terminals as shown below. These terminals
accept two #14AWG wires.
20151
L1 — 120/240 V
L2 — V ac NEUTRAL
ATTENTION: Turn off power lines before
connecting power; failure to do so could
cause injury to personnel and/or equipment.
— PE
PWR OUT +24 V dc
PWR OUT COM
Table 10A.AL
1746 P1 Power Supply Specifications
Description: Specification:
Line Voltage 85--132/170--265 V ac
50/60 Hz
Typical Line Power Requirement 135 VA
Internal Current Capacity 2 AMP at 5 V dc
0.46 AMP at 24 V dc
User Current Capacity 24 V dc -- 0.2 AMP
Fuse Protection 3 AMPs
Ambient Operating Temperature Rating 0 to +55°C
(Current capacity derated by 5% at +60°C)
Humidity Rating 5 -- 95% (noncondensing)
Wiring #14 AWG