Rockwell Automation 8520 9/Series CNC Integration Maintenance Manual Documentation Set - Manual (Page 745)

Section 15A
Troubleshooting the Control
15A-35
There are two sets of diagnostic screens that provide detailed information
on the operation and status of the servo system.
Axis monitor diagnostic screens
1394 Drive status screens
The axis monitor screens are available on all 9/Series controls. The “1394
DRIVE” status screen described here is available only on 9/440 systems.
Note that there are comparable screens for the 9/260 and 9/290 under the
“RING I/O” monitor screens.
To access these two types of servo system displays, make the following
softkey selections : [SYSTEM SUPPORT]
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
then [MONITOR].
(softkey level 2)
PRGRAM
MANAGE
AMP DEVICE
SETUP
MONI-
TOR
TIME
PARTS
Subsequent selections are detailed in the following sections .
When the {AXIS MONTOR} softkey is pressed on the Main Diagnostics
Menu screen, the Axis Monitor screen appears. “AXIS MONITOR”
appears at the top to identify the screen, along with the “SETUP MODE”
message indicating that the control is in setup diagnostics mode.
(softkey level 3)
RING
I/O
REMOTE
I/O
FAST
I/O
AXIS
MONTOR
SERIAL
I/O
15A.7
Servo Diagnostic Displays
15A.7.1
Axis Monitor Diagnostics