Brocade TurboIron 24X Series Configuration Guide User Manual
Page 98

64
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Securing access methods
Telnet access
Not secured
Regulate Telnet access using ACLs
Allow Telnet access only from specific IP
addresses
Restrict Telnet access based on a client MAC
address
Allow Telnet access only from specific MAC
addresses
Specify the maximum number of login attempts
for Telnet access
Disable Telnet access
Establish a password for Telnet access
Establish passwords for privilege levels of the
CLI
Set up local user accounts
Configure TACACS/TACACS+ security
Configure RADIUS security
Secure Shell (SSH) access Not configured
Configure SSH
page 945
Regulate SSH access using ACLs
Allow SSH access only from specific IP
addresses
Allow SSH access only from specific MAC
addresses
Establish passwords for privilege levels of the
CLI
Set up local user accounts
Configure TACACS/TACACS+ security
Configure RADIUS security
SNMP (Brocade Network
Advisor) access
SNMP read or
read-write
community strings
and the password
to the Super User
privilege level
NOTE: SNMP read
or
read-write
community
strings are
always
required
for SNMP
access to
the device.
Regulate SNMP access using ACLs
Allow SNMP access only from specific IP
addresses
Disable SNMP access
Allow SNMP access only to clients connected to
a specific VLAN
Establish passwords to management levels of
the CLI
Set up local user accounts
Establish SNMP read or read-write community
strings
TABLE 18
Ways to secure management access to devices (Continued)
Access method
How the access
method is secured
by default
Ways to secure the access method
See page