Brocade TurboIron 24X Series Configuration Guide User Manual
Page 1091

Brocade TurboIron 24X Series Configuration Guide
1057
53-1003053-01
Syslog messages
Informational
MAC Based Vlan Disabled on port
A MAC Based VLAN has been disabled on a
port
Informational
MAC Based Vlan Enabled on port
A MAC Based VLAN has been enabled on a
port.
Informational
MAC Filter added | deleted | modified from
console | telnet | ssh | web | snmp session
filter id =
A user created, modified, deleted, or
applied this MAC filter through the Web,
SNMP, console, SSH, or Telnet session.
Informational
MSTP: BPDU-guard interface ethernet
putting into err-disable state.
BPDU guard violation occurred in MSTP.
Informational
OPTICAL MONITORING: port
is not capable.
The optical transceiver is qualified by
Brocade, but the transceiver does not
support digital optical performance
monitoring.
Informational
Port
priority changed to
A port priority has changed.
Informational
Port
max-ipaddr-per-int reached.Last
IP=
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational
Port
max-ipaddr-per-int reached.Last
IP=
The address limit specified by the
srcip-security max-ipaddr-per-interface
command has been reached for the port.
Informational
Security: console login by
USER | PRIVILEGE EXEC mode
The specified user logged into the device
console into the specified EXEC mode.
Informational
Security: console logout by
The specified user logged out of the device
console.
Informational
Security: telnet | SSH login by
from src IP
mode
The specified user logged into the device
using Telnet or SSH from either or both the
specified IP address and MAC address. The
user logged into the specified EXEC mode.
Informational
Security: telnet | SSH logout by
from src IP
mode
The specified user logged out of the device.
The user was using Telnet or SSH to access
the device from either or both the specified
IP address and MAC address. The user
logged out of the specified EXEC mode.
Informational
SNMP read-only community | read-write
community | contact | location | user |
group | view | engineld | trap [host] [
console | telnet | ssh | web | snmp session
A user made SNMP configuration changes
through the Web, SNMP, console, SSH, or
Telnet session.
[
message if SNMP community or engineld is
specified.
Informational
SNMP Auth. failure, intruder IP:
A user has tried to open a management
session with the device using an invalid
SNMP community string.
The
that sent the invalid community string.
TABLE 176
Brocade Syslog messages (Continued)
Message level
Message
Explanation