Brocade TurboIron 24X Series Configuration Guide - Manual (Page 216)

182 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Reading CDP packets
Clearing FDP and CDP statistics
To clear FDP and CDP statistics, enter the following command.
TurboIron#clear fdp counters
Syntax: clear fdp counters
Reading CDP packets
Cisco Discovery Protocol (CDP) packets are used by Cisco devices to advertise themselves to other
Cisco devices. By default, devices forward these packets without examining their contents. You
can configure a device to intercept and display the contents of CDP packets. This feature is useful
for learning device and interface information for Cisco devices in the network.
Devices support intercepting and interpreting CDP version 1 and version 2 packets.
NOTE
The Brocade device can interpret only the information fields that are common to both CDP version
1 and CDP version 2.
NOTE
When you enable interception of CDP packets, the Brocade device drops the packets. As a result,
Cisco devices will no longer receive the packets.
Enabling interception of CDP packets globally
To enable the device to intercept and display CDP packets, enter the following command at the
global CONFIG level of the CLI.
TurboIron(config)#cdp run
Syntax: [no] cdp run
The feature is disabled by default.
Enabling interception of CDP packets on an interface
You can disable and enable CDP at the interface level.
You can enter commands such as the following.
TurboIron(config)#int e 1
TurboIron(config-if-1)#cdp enable
Syntax: [no] cdp enable
By default, the feature is enabled on an interface once CDP is enabled on the device.
Displaying CDP information
You can display the following CDP information:
• Cisco neighbors