Brocade TurboIron 24X Series Configuration Guide - Manual (Page 670)

636 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring OSPF
The following command shows the result of the redistribution filter. Since only one of the static IP
routes configured above matches the route map, only one route is redistributed. Notice that the
route metric is 5 before redistribution but is 8 after redistribution.
Syntax: [no] redistribution bgp | connected | rip | static [route-map ]
The bgp | connected | rip | static parameter specifies the route source.
The route-map parameter specifies the route map name. The following match
parameters are valid for OSPF redistribution:
• match ip address | next-hop
• match metric
• match tag
The following set parameters are valid for OSPF redistribution:
• set ip next hop
• set metric [+ | - ] | none
• set metric-type type-1 | type-2
• set tag
NOTE
You must configure the route map before you configure a redistribution filter that uses the route
map.
NOTE
When you use a route map for route redistribution, the software disregards the permit or deny action
of the route map.
NOTE
For an external route that is redistributed into OSPF through a route map, the metric value of the
route remains the same unless the metric is set by a set metric command inside the route map. The
default-metric command has no effect on the route. This behavior is different from a route
that is redistributed without using a route map. For a route redistributed without using a route map,
the metric is set by the default-metric command.
Disable or re-enable load sharing
Routers can load share among up to eight equal-cost IP routes to a destination. By default, IP load
sharing is enabled. The default is 4 equal-cost paths but you can specify from 2 – 6 paths.
TurboIron#show ip ospf database external extensive
Index Aging LS ID Router Netmask Metric Flag
1 2 10.4.4.0 10.10.10.60 ffff0000 80000008 0000