Brocade TurboIron 24X Series Configuration Guide - Manual (Page 35)

Brocade TurboIron 24X Series Configuration Guide 1
53-1003053-01
Chapter
1
Feature Highlights
In this chapter
• Supported features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
• Supported IPv6 management features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
• Unsupported features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Introduction to features
The features that are available on a device depend on the type of software image the device is
running. You can run one of the following types of software images on these devices:
• Layer 2 is supported on all models
• Layer 3 features supported on TurboIron devices only.
Table 2 lists the software that is loaded into the primary and secondary flash areas at the factory.
Supported features
The tables in this section list the feature highlights in the TurboIron software.
Supported management features
Table 3 lists the supported management features. These features are supported in the Layer 2
software images..
TABLE 2 Default software loads
Model Software images
Primary flash Secondary flash
All TurboIron models Layer 2 Layer 2
TABLE 3 Supported management features
Category, description, and configuration
notes TurboIron X Series
AAA support for console commands Yes
Access Control Lists (ACLs) for controlling
management access Yes
Alias Command Yes