Vrrpe example, Configuring router1 – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 929
Brocade TurboIron 24X Series Configuration Guide
895
53-1003053-01
Configuration examples
NOTE
When you configure a Backup router, the router interface on which you are configuring the VRID
must have a real IP address that is in the same subnet as the address associated with the VRID by
the Owner. However, the address cannot be the same.
The priority parameter establishes the router VRRP priority in relation to the other VRRP routers in
this virtual router. The track-priority parameter specifies the new VRRP priority that the router
receives for this VRID if the interface goes down. Refer to
“Track ports and track priority”
The activate command activates the VRID configuration on this interface. The interface does not
provide backup service for the virtual IP address until you activate the VRRP configuration.
Syntax: router vrrp
Syntax: ip vrrp vrid
Syntax: owner [track-priority
Syntax: backup [priority
Syntax: track-port ethernet
Syntax: ip-address
Syntax: activate
VRRPE example
To implement the VRRPE configuration shown in
on page 869, use the following CLI
method.
Configuring Router1
To configure VRRP Router1 in
on page 869, enter the following commands.
Router1(config)#router vrrp-extended
Router1(config)#interface ethernet 6
Router1(config-if-6)#ip address 10.53.5.2/24
Router1(config-if-6)#ip vrrp-extended vrid 1
Router1(config-if-6-vrid-1)#backup priority 110 track-priority 20
Router1(config-if-6-vrid-1)#track-port ethernet 4
Router1(config-if-6-vrid-1)#ip-address 10.53.5.254
Router1(config-if-6-vrid-1)#activate
VRRP router 1 for this interface is activating
Router1(config-if-6-vrid-1)#exit
Router1(config)#interface ethernet 6
Router1(config-if-6)#ip vrrp-extended vrid 2
Router1(config-if-6-vrid-1)#backup priority 100 track-priority 20
Router1(config-if-6-vrid-1)#track-port ethernet 4
Router1(config-if-6-vrid-1)#ip-address 10.53.5.253
Router1(config-if-6-vrid-1)#activate
VRRP router 2 for this interface is activating
NOTE
The address you enter with the ip-address command cannot be the same as a real IP address
configured on the interface.