Brocade TurboIron 24X Series Configuration Guide - Manual (Page 1010)

976 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying 802.1X information
• The number of users connected on each port in a 802.1X multiple-host configuration
Displaying 802.1X multiple-host configuration information
The output of the show dot1x and show dot1x config commands displays information related to
802.1X multiple-host authentication.
The following is an example of the output of the show dot1x command. The information related to
multiple-host authentication is highlighted in bold.
Syntax: show dot1x
Table 149 describes the bold fields in the display.
The output of the show dot1x config command for an interface displays the configured port control
for the interface. Starting in release 02.2.00, this command also displays information related to
802.1X multiple host-authentication.
The following is an example of the output of the show dot1x config command for an interface.
TABLE 149 Output from the show dot1x command for multiple host authentication
This field... Displays...
Authentication-fail-action The configured authentication-failure action. This can be Restricted
VLAN or Block Traffic.
Authentication Failure VLAN If the authentication-failure action is Restricted VLAN, the ID of the VLAN
to which unsuccessfully authenticated Client ports are assigned.
Mac Session Aging Whether aging for dot1x-mac-sessions has been enabled or disabled for
permitted or denied dot1x-mac-sessions.
Mac Session max-age The configured software aging time for dot1x-mac-sessions.
Flow based multi-user policy The dynamically assigned IP ACLs and MAC address filters used in the
802.1X multiple-host configuration.
TurboIron#show dot1x
Number of Ports enabled : 2
Re-Authentication : Enabled
Authentication-fail-action : Restricted VLAN
Authentication Failure VLAN : 111
Mac Session Aging : Disabled for permitted MAC sessions
Mac Session max-age : 60 seconds
Protocol Version : 1
quiet-period : 5 Seconds
tx-period : 30 Seconds
supptimeout : 30 Seconds
servertimeout : 30 Seconds
maxreq : 2
re-authperiod : 3600 Seconds
security-hold-time : 60 Seconds
re-authentication : Enable
Flow based multi-user policy : Disable