Displaying ospf information, Displaying general ospf configuration information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 680

646
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying OSPF information
This command clears all OSPF areas, all OSPF neighbors, and the entire OSPF routing table. After
this information has been cleared, adjacencies with all neighbors are re-established, and all OSPF
routes are re-learned.
To clear information on the device about OSPF area 1, enter the following command.
TurboIron#clear ip ospf area 1
This command clears information about the specified area ID. Information about other OSPF areas
is not affected. The command clears information about all OSPF neighbors belonging to the
specified area, as well as all routes imported into the specified area. Adjacencies with neighbors
belonging to the area are re-established, and routes imported into the area are re-learned.
Syntax: clear ip ospf [area
The
Displaying OSPF information
You can use CLI commands to display the following OSPF information:
•
Trap, area, and interface information – refer to
“Displaying general OSPF configuration
•
CPU utilization statistics – refer to
“Displaying CPU utilization statistics”
•
Area information – refer to
“Displaying OSPF area information”
•
Neighbor information – refer to
“Displaying OSPF neighbor information”
•
Interface information – refer to
“Displaying OSPF interface information”
•
“Displaying OSPF route information”
•
External link state information – refer to
“Displaying OSPF external link state information”
•
Link state information – refer to
“Displaying OSPF link state information”
•
Virtual Neighbor information – refer to
“Displaying OSPF virtual neighbor information”
•
Virtual Link information – refer to
“Displaying OSPF virtual link information”
•
ABR and ASBR information – refer to
“Displaying OSPF ABR and ASBR information”
•
Trap state information – refer to
Displaying general OSPF configuration information
To display general OSPF configuration information, enter the following command at any CLI level.