Displaying ipv6 interface information – Brocade TurboIron 24X Series Configuration Guide User Manual
Page 186

152
Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying global IPv6 information
Syntax: show ipv6 cache [
ethernet
•
The
number and subsequent entries.
•
The
specified IPv6 prefix. You must specify the
16-bit values between colons as documented in RFC 2373. You must specify the
<prefix-length> parameter as a decimal value. A slash mark (/) must follow the <ipv6-prefix>
parameter and precede the <prefix-length> parameter.
•
The ethernet | ve | tunnel parameters restrict the display to the entries for the specified
interface. The <ipv6-address> parameter restricts the display to the entries for the specified
IPv6 address. You must specify this parameter in hexadecimal using 16-bit values between
colons as documented in RFC 2373.
•
If you specify an Ethernet interface, also specify the port number associated with the interface.
If you specify a VE interface, also specify the VE number. If you specify a tunnel interface, also
specify the tunnel number.
This display shows the following information.
Displaying IPv6 interface information
To display IPv6 interface information, enter the following command at any CLI level.
Syntax: show ipv6 interface [
TABLE 31
IPv6 cache information fields
This field...
Displays...
Total number of cache entries
The number of entries in the cache table.
IPv6 Address
The host IPv6 address.
Next Hop
The next hop, which can be one of the following:
•
Direct – The next hop is directly connected to the router.
•
Local – The next hop is originated on this router.
•
Port
The port on which the entry was learned.
TurboIron#show ipv6 interface
Interface Status Routing Global Unicast Address
Ethernet 3 down/down R
Ethernet 5 down/down
Ethernet 17 up/up 2001:DB8::c017:101/64
Ethernet 19 up/up 2001:DB8::c019:101/64
VE 4 down/down
VE 14 up/up 2001:DB8::c060:101/64
Loopback 1 up/up 2001:DB8::1/128
Loopback 2 up/up 2001:DB8::303:303/128
Loopback 3 up/up