Brocade TurboIron 24X Series Configuration Guide - Manual (Page 683)

Brocade TurboIron 24X Series Configuration Guide 649
53-1003053-01
Displaying OSPF information
Displaying OSPF area information
To display OSPF area information, enter the following command at any CLI level.
Syntax: show ip ospf area [] | []
The parameter shows information for the specified area.
The parameter displays the entry that corresponds to the entry number you enter. The
entry number identifies the entry position in the area table.
This display shows the following information.
Displaying OSPF neighbor information
To display OSPF neighbor information, enter the following command at any CLI level.
To display detailed OSPF neighbor information, enter the following command at any CLI level.
TABLE 98 CLI display of OSPF area information
This field... Displays...
Indx The row number of the entry in the router OSPF area table.
Area The area number.
Type The area type, which can be one of the following:
•
nssa
•
normal
•
stub
Cost The area cost.
SPFR The SPFR value.
ABR The ABR number.
ASBR The ABSR number.
LSA The LSA number.
Chksum(Hex) The checksum for the LSA packet. The checksum is based on all the fields in the packet
except the age field. The Layer 3 Switch uses the checksum to verify that the packet is
not corrupted.
TurboIron#show ip ospf area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0.0.0.0 normal 0 1 0 0 1 0000781f
2 10.147.60.0 normal 0 1 0 0 1 0000fee6
3 10.147.80.0 stub 1 1 0 0 2 000181cd
TurboIron#show ip ospf neighbor
Port Address Pri State Neigh Address Neigh ID
8 10.76.7.251 1 full 10.76.7.200 10.35.1.220