beautypg.com

Disabling or re-enabling syslog, Specifying a syslog server, Specifying an additional syslog server – Brocade TurboIron 24X Series Configuration Guide User Manual

Page 261

background image

Brocade TurboIron 24X Series Configuration Guide

227

53-1003053-01

Configuring the Syslog service

Disabling or re-enabling Syslog

Syslog is enabled by default. To disable it, enter the following command at the global CONFIG level.

TurboIron(config)#no logging on

Syntax: [no] logging on []

The parameter specifies the application port used for the Syslog facility. The default is
514.

To re-enable logging, enter the following command.

TurboIron(config)#logging on

This command enables local Syslog logging with the following defaults:

Messages of all severity levels (Emergencies – Debugging) are logged.

Up to 50 messages are retained in the local Syslog buffer.

No Syslog server is specified.

Specifying a Syslog server

To specify a Syslog server, enter a command such as the following.

TurboIron(config)#logging host 10.0.0.99

Syntax: logging host |

Specifying an additional Syslog server

To specify an additional Syslog server, enter the logging host command again, as in the
following example. You can specify up to six Syslog servers.

TurboIron(config)#logging host 10.0.0.99

Syntax: logging host |

TurboIron#show logging

Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)

Buffer logging: level ACDMEINW, 38 messages logged

level code: A=alert C=critical D=debugging M=emergency E=error

I=informational N=notification W=warning

Static Log Buffer:

Dynamic Log Buffer (50 entries):

21d07h02m40s:warning:list 101 denied tcp 10.157.22.191(0)(Ethernet18

0000.001f.77ed) -> 10.99.4.69(http), 1 event(s)

19d07h03m30s:warning:list 101 denied tcp 10.157.22.26(0)(Ethernet 18

0000.001f.77ed) -> 10.99.4.69(http), 1 event(s)

17d06h58m30s:warning:list 101 denied tcp 10.157.22.198(0)(Ethernet18

0000.001f.77ed) -> 10.99.4.69(http), 1 event(s)