beautypg.com

Displaying arp entries – Brocade TurboIron 24X Series Configuration Guide User Manual

Page 541

background image

Brocade TurboIron 24X Series Configuration Guide

507

53-1003053-01

Displaying IP configuration information and statistics

Syntax: show ip

This display shows the following information.

Displaying ARP entries

To display the entries the Layer 2 Switch has placed in its ARP cache, enter the following command
from any level of the CLI.

Syntax: show arp

This display shows the following information.

TABLE 82

CLI display of global IP configuration information – Layer 2 Switch

This field...

Displays...

IP configuration

Switch IP address

The management IP address configured on the Layer 2 Switch. Specify this
address for Telnet access.

Subnet mask

The subnet mask for the management IP address.

Default router address

The address of the default gateway, if you specified one.

Most recent TFTP access

TFTP server address

The IP address of the most-recently contacted TFTP server, if the switch has
contacted a TFTP server since the last time the software was reloaded or the
switch was rebooted.

Configuration filename

The name under which the Layer 2 Switch startup-config file was uploaded or
downloaded during the most recent TFTP access.

Image filename

The name of the Layer 2 Switch flash image (system software file) that was
uploaded or downloaded during the most recent TFTP access.

TurboIron#show ip

Switch IP address: 192.168.1.2

Subnet mask: 255.255.255.0

Default router address: 192.168.1.1

TFTP server address: None

Configuration filename: None

Image filename: None

TurboIron#show arp

IP Mac Port Age VlanId

192.168.1.170 0000.0011.d042 7 0 1

Total Arp Entries : 1