Brocade TurboIron 24X Series Configuration Guide User Manual
Page 1009

Brocade TurboIron 24X Series Configuration Guide
975
53-1003053-01
Displaying 802.1X information
Syntax: show dot1x ip-ACL
Displaying dynamically applied MAC filters and IP ACLs
To display the dynamically applied MAC address filters active on an interface, enter a command
such as the following.
Syntax: show dot1x mac-address-filter all | ethernet
The all keyword displays all dynamically applied MAC address filters active on the device.
The
To display the dynamically applied IP ACLs active on an interface, enter a command such as the
following.
Syntax: show dot1x ip-ACL all | ethernet
The all keyword displays all dynamically applied IP ACLs active on the device.
The
Displaying 802.1X multiple-host authentication
information
You can display the following information about 802.1X multiple-host authentication:
•
Information about the 802.1X multiple-host configuration
•
The dot1x-mac-sessions on each port
TurboIron#show dot1x ip-ACL
Port 3 (User defined IP ACLs):
Extended IP access list Port_3_E_IN
permit udp any any
Extended IP access list Port_3_E_OUT
permit
dp an
an
TurboIron#show dot1x mac-address-filter e 3
Port 3 MAC Address Filter information:
802.1X Dynamic MAC Address Filter :
mac filter-group 2
Port default MAC Address Filter:
No mac address filter is set
TurboIron#show dot1x ip-ACL e 3
Port 3 IP ACL information:
802.1X dynamic IP ACL (user defined) in:
ip access-list extended Port_3_E_IN in
Port default IP ACL in:
No inbound ip access-list is set
802.1X dynamic IP ACL (user defined) out:
ip access-list extended Port_3_E_OUT out
Port default IP ACL out:
No outbound ip access-list is set