Brocade TurboIron 24X Series Configuration Guide - Manual (Page 876)

842 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Multicast Source Discovery Protocol (MSDP)
Configuration for Device C
The following set of commands configure the MSDP peers of Device C (10.1.3.1) that are inside
and outside MSDP mesh group 1234. Device C peers inside the mesh group 1234 are 10.1.1.1,
10.1.2.1, and 10.1.4.1. Device 10.35.35.5 is a peer of Device C, but is outside mesh group 1234.
Multicast is enabled on Device C interfaces. PIM and BGP are also enabled. This configuration is
not applicable to TurboIron X Series devices because BGP is not supported on the device.
TurboIron(config)#router pim
TurboIron(config)#router msdp
TurboIron(config-msdp-router)#msdp-peer 10.35.35.5
TurboIron(config-msdp-router)#msdp-peer 10.1.2.1 connect-source loopback 1
TurboIron(config-msdp-router)#msdp-peer 10.1.4.1 connect-source loopback 1
TurboIron(config-msdp-router)#msdp-peer 10.1.1.1 connect-source loopback 1
TurboIron(config-msdp-router)#mesh-group 1234 10.1.2.1
TurboIron(config-msdp-router)#mesh-group 1234 10.1.1.1
TurboIron(config-msdp-router)#mesh-group 1234 10.1.4.1
TurboIron(config-msdp-router)#exit
TurboIron(config)#interface loopback 1
TurboIron(config-lbif-1)#ip address 10.1.3.1 255.255.255.0
TurboIron(config-lbif-1)#ip pim-sparse
TurboIron(config-lbif-1)#exit
TurboIron(config)#interface ethernet 3/1
TurboIron(config-if-3/1)#ip address 10.32.32.3 255.255.255.0
TurboIron(config-if-3/1)#ip pim-sparse
TurboIron(config-if-3/1)#exit
TurboIron(config)#interface ethernet 10/1
TurboIron(config-if-10/1)#ip address 10.31.31.3 255.255.255.0
TurboIron(config-if-10/1)#ip pim-sparse
TurboIron(config-if-10/1)#exit
TurboIron(config)#interface ethernet 10/8
TurboIron(config-if-10/8)#ip address 10.35.35.3 255.255.255.0
TurboIron(config-if-10/8)#ip pim-sparse
TurboIron(config-if-10/8)#ip pim border
TurboIron(config-if-10/8)#exit
TurboIron(config)#interface ethernet 12/2
TurboIron(config-if-12/1)#ip address 10.34.34.3 255.255.255.0
TurboIron(config-if-12/1)#ip pim-sparse
TurboIron(config-if-12/1)#exit
TurboIron(config)#interface ethernet 14/4
TurboIron(config-if-14/4)#ip address 10.154.154.1 255.255.255.0
TurboIron(config-if-12/1)#ip pim-sparse
TurboIron(config-if-12/1)#exit
TurboIron(config)#router pim
TurboIron(config-router-pim)#bsr-candidate loopback 1 1 3
TurboIron(config-router-pim)#rp-candidate loopback 1
TurboIron(config-router-pim)#exit
TurboIron(config)#router bgp
TurboIron(config-router-bsr)#local-as 333
TurboIron(config-router-bsr)#neighbor 10.35.35.5 remote-as 555
TurboIron(config-router-bsr)#neighbor 10.35.35.5 next-hop-self