Brocade TurboIron 24X Series Configuration Guide - Manual (Page 852)

818 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
PIM Sparse
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for a PIM Sparse group
• RP set list
• PIM Neighbor information
• The PIM flow cache
• The PIM multicast cache
• PIM traffic statistics
Displaying basic PIM Sparse configuration information
To display basic configuration information for PIM Sparse, enter the following command at any CLI
level.
Syntax: show ip pim sparse
This example shows the PIM Sparse configuration information on PIM Sparse router A in
Figure 106 .
This display shows the following information.
TABLE 117 Output of show ip pim sparse
This field... Displays...
Global PIM Sparse mode settings
Hello interval How frequently the Layer 3 Switch sends PIM Sparse hello messages to its PIM Sparse
neighbors. This field show the number of seconds between hello messages. PIM Sparse
routers use hello messages to discover one another.
Neighbor timeout How many seconds the Layer 3 Switch will wait for a hello message from a neighbor
before determining that the neighbor is no longer present and removing cached PIM
Sparse forwarding entries for the neighbor.
TurboIron#show ip pim sparse
Global PIM Sparse Mode Settings
Hello interval: 60, Neighbor timeout: 180
Bootstrap Msg interval: 130, Candidate-RP Advertisement interval: 60
Join/Prune interval: 60, SPT Threshold: 1
Interface Ethernet e8
TTL Threshold: 1, Enabled
Local Address: 10.95.8.1
Interface Ve 1
TTL Threshold: 1, Enabled
Local Address: 10.95.6.1