Brocade TurboIron 24X Series Configuration Guide - Manual (Page 300)

266 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Displaying and modifying system parameter default settings
Table 51 defines the system parameters in the show default values command output.
TABLE 51 System parameters in show default values command
This system parameter... Defines the maximum number of...
atalk-route Appletalk routes
atalk-zone-port Appletalk zones per port
atalk-zone-sys Appletalk zones per system
hw-ip-mcast-mll Multicast output interfaces (clients)
hw-ip-next-hop IP next hops and routes, including unicast next hops and multicast route
entries
hw-logical-interface Hardware logical interface pairs (physical port and VLAN pairs)
hw-traffic-conditioner Traffic policies
ip-arp ARP entries
ip-cache IP forwarding cache entries
ip-filter-port IP ACL entries per port
ip-filter-sys IP ACL entries per system
ip-qos-session Layer 4 session table entries
ip-route Learned IP routes
ip-static-arp Static IP ARP entries
ip-static-route Static IP routes
ip-subnet-port IP subnets per port
ipx-forward-filter IPX forward filter entries
ipx-rip-entry IPX RIP entries
ipx-rip-filter IPX RIP filter entries
ipx-sap-entry IPX SAP entries
ipx-sap-filter IPX SAP filter entries
l3-vlan Layer 3 VLANs
mac MAC entries
mac-filter-port MAC filter entries per port
mac-filter-sys MAC filter entries per system
multicast-route Multicast routes
pim-mcache PIM multicast cache entries
TurboIron#show default values
Minimun Maximum Current
multicast-route 1024 2048 1024
pim-mcache 1024 4096 4096
igmp-max-group-addr 4096 8192 4096
igmp-snoop-mcache 512 2048 512
msdp-sa-cache 1024 4096 1024