Brocade TurboIron 24X Series Configuration Guide - Manual (Page 818)

784 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
IGMP snooping show commands
Syntax: show ip multicast error
The following table describes the output from the show ip multicast error command.
Displaying IGMP group information
To display information about IGMP groups, enter the following command.
In this example, an IGMP V2 group is in EXCLUDE mode with a source of 0. The group only excludes
traffic from the 0 (zero) source list, which actually means that all traffic sources are included.
To display detailed IGMP group information for a specific group, enter the following command.
If the tracking and fast leave features are enabled, you can display the list of clients that belong to
a particular group by entering the following command.
Syntax: show ip multicast group [<group-address> [detail] [tracking]]
Table 0.4:
This field Displays
SW processed pkt The number of multicast packets processed by IGMP snooping.
up-time The time since the IGMP snooping is enabled.
TurboIron#show ip multicast group
p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no
VL70 : 3 groups, 4 group-port, tracking_enabled
group p-port ST QR life mode source
1 224.1.1.2 33 no yes 120 EX 0
2 224.1.1.1 33 no yes 120 EX 0
3 226.1.1.1 35 yes yes 100 EX 0
4 226.1.1.1 33 yes yes 100 EX 0
TurboIron#show ip multicast group 226.1.1.1 detail
Display group 226.1.1.1 in all interfaces in details.
p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no
VL70 : 1 groups, 2 group-port, tracking_enabled
group p-port ST QR life mode source
1 226.1.1.1 35 yes yes 120 EX 0
group: 226.1.1.1, EX, permit 0 (source, life):
life=120, deny 0:
group p-port ST QR life mode source
2 226.1.1.1 33 yes yes 120 EX 0
group: 226.1.1.1, EX, permit 0 (source, life):
life=120, deny 0:
TurboIron#show ip multicast group 224.1.1.1 tracking
Display group 224.1.1.1 in all interfaces with tracking enabled.
p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no
VL70 : 1 groups, 1 group-port, tracking_enabled
group p-port ST QR life mode source
*** Note: has 1 static groups to the entire vlan, not displayed here
1 224.1.1.1 33 no yes 100 EX 0
receive reports from 1 clients: (age)
(10.2.100.2 60)